我家的吸尘机

Power switch 　
　　The power switch is located on the end of the curved handle. 　
　　To turn hand vacuum ON ( I ), press up. 　
　　To turn hand vacuum OFF ( 0 ), press down 　
　　Cleaning with flexible rubber contour nozzle 　
　　1. Turn hand vacuum OFF. 　
　　2. Remove hard nozzle by pressing down on 　
　　round nozzle release button. 　
　　3. Replace with flexible rubber contour nozzle by lining 　
　　up the bottom of nozzle to the bottom of the dirt 　
　　container. Pivot upwards until it snaps into place. 　
　　4. Make sure the nozzle has snapped securely 　
　　into place before using 　
　　Emptying the dirt container 　
　　Empty the dirt container after each use. A 　
　　full dirt container may reduce suction or 　
　　performance of vacuum. 　
　　1. Turn hand vacuum OFF. 　
　　2. Unplug hand vacuum from electrical outlet. 　
　　3. Press dirt container release latch down to 　
　　disconnect dirt container and filter assembly 　
　　from the unit. 　
　　4. Remove filter by grasping tabs on both sides 　
　　of filter frame and pulling away from the dirt 　
　　container. For best results, periodically tap 　
　　filter assembly against trash can to remove 　
　　dirt that has collected on the screen and 　
　　filter. 　
　　5. Empty dirt into trash can. 　
　　6. Replace filter assembly by aligning side 　
　　labeled “TOP” into top of dirt container. 　
　　Grasp filter tabs and press firmly to ensure 　
　　filter assembly is secure in dirt container. 　
　　NOT E: Make sure side of filter assembly 　
　　labeled "TO P" faces outward when inserting 　
　　filter assembly into dirt container. 　
　　7. Reattach dirt container to unit by aligning 　
　　bottom of dirt container to bottom of unit. 　
　　Pivot upwards and snap into place. Use one 　
　　hand to hold the unit and use the other hand 　
　　to clip the dirt container securely in place